Antique Farmall Tractors Forums: Engine Problems - Antique Farmall Tractors Forums

Jump to content

Icon Important Announcement!

We recently suffered from a hard drive failure and the back up of the forum was bad so we searched for a good back up and the only one we found was from 2006. We lost 3 years of members and posts but we are going to continue to rebuild the forum. We now have a new back up solution in place so by all means signup.

Scott
Admin


Page 1 of 1
  • You cannot start a new topic
  • You cannot reply to this topic

Engine Problems Water in cylnder

#1 User is offline   TREE Icon

  • Newbie
  • Pip
Group:
Members
Posts:
1
Joined:
10-September 04

Posted 13 September 2004 - 10:25 PM

I just purchased a Farmall A, it appeared the engine had ceased. I removed the spark plugs to find water in #2 cylinder. I turned over the engine and sprayed oil in the cylinders, but the #2 cyl. keeps spitting water. Any suggestions on this would be greatly appreciated?
0

#2 User is offline   DanO Icon

  • Newbie
  • Pip
Group:
Members
Posts:
3
Joined:
23-July 10

Posted 23 July 2010 - 05:40 PM

View PostTREE, on 13 September 2004 - 10:25 PM, said:

I just purchased a Farmall A, it appeared the engine had ceased. I removed the spark plugs to find water in #2 cylinder. I turned over the engine and sprayed oil in the cylinders, but the #2 cyl. keeps spitting water. Any suggestions on this would be greatly appreciated?



I'm Afraid you have a Blown Head Gasket...that's why the water/antifreeze is getting in. Hopfully it's just the gasket and the head isn't warped but removing the head & replaciong the gasket is not a big deal at all. Once you have the head off you can check out all the other cylinders as well. Good Luck, DanO
0
Page 1 of 1
  • You cannot start a new topic
  • You cannot reply to this topic

1 User(s) are reading this topic
0 members, 1 guests, 0 anonymous users