Antique Farmall Tractors Forums: Looking For General Rules - Antique Farmall Tractors Forums

Jump to content

Icon Important Announcement!

We recently suffered from a hard drive failure and the back up of the forum was bad so we searched for a good back up and the only one we found was from 2006. We lost 3 years of members and posts but we are going to continue to rebuild the forum. We now have a new back up solution in place so by all means signup.

Scott
Admin


Page 1 of 1
  • You cannot start a new topic
  • You cannot reply to this topic

Looking For General Rules for Antique Tractor pulls

#1 User is offline   squeakyzig Icon

  • Member
  • PipPip
Group:
Members
Posts:
19
Joined:
30-September 04

Posted 08 December 2004 - 04:06 PM

We have a '47 B that I'm hopefully going to be able to use this spring for some tractor pulls. Does anyone have a list of general rules for Texas?

My husband says I can't be in the pull without wheelie bars. Is this true?

any help would be appreciated.

thanks.

rolleyes.gif
0

#2 User is offline   kidagin Icon

  • Member
  • PipPip
Group:
Members
Posts:
18
Joined:
03-October 04

Posted 09 December 2004 - 10:32 PM

I responded to most of your question in the Farmall B section, but let me add what I know about Texas. The pulls I've been to in Texas were using either EDGE&TA (Early Day Gas Engine & Tractor Ass'n) or NATPA (National Antique Tractor Pullers Ass'n) rules or some variation thereof. The EDGE&TA rules are more restrictive in terms of modifications--basically they require that you don't stray much from the stock form of the tractor. I would say most of the pullers I've seen didn't have wheelie bars.

Hope this helps.
McCormick 10-20, SW4, SW6, O6, WDR9, Farmall F 20, SAV, B, C, M; International W400.
0

#3 User is offline   squeakyzig Icon

  • Member
  • PipPip
Group:
Members
Posts:
19
Joined:
30-September 04

Posted 10 December 2004 - 01:42 PM

thanks kidagin. I'll check out those website.


0
Page 1 of 1
  • You cannot start a new topic
  • You cannot reply to this topic

1 User(s) are reading this topic
0 members, 1 guests, 0 anonymous users