Jump to content

Please visit Our Sponsors

If you have never posted before on the board your first post will not show until approved by an admin and you will be changed to a Posting Member so you can post without prior approval. This is done to control the spammers that try to spam forums.


'67 Farmall 140 Problem

  • Please log in to reply
No replies to this topic

#1 rock



  • Posting Member
  • Pip
  • 1 posts

Posted October 16 2012 - 07:03 PM

I recently converted my dad's 140 from 6 volt positive ground to 12 volt negative ground. It's been stored(inside) for about 2-3 years without being used. I replaced the alt..removed the voltage reg....replaced the ig coil with a 12 volt coil with a internal bal resis. Replaced the points and conden...fresh gas/oil. When I hit the starter..it fired up and ran(good) with full trottle only. No matter what i do...it runs with full trottle only. Checked all linkage/levers...they appear to be working fine. Pulled the gov housing off..nothing appears broken. Does anyone have any suggestions? Thanks!

0 user(s) are reading this topic

0 members, 0 guests, 0 anonymous users